***We have redesigned our sights to streamline manufacturing. These sights are being sold at a very low price to make way for the new generation sights.***
Our sight systems are made from 17-4 PH stainless steel for a durable and tough sight that will withstand years of hard use. On top of that is a Black Nitride finish for corrosion and abrasion resistance. The sights are designed to be as fast as possible while allowing for maximum accuracy. This is in part achieved by the profile of the rear sight which is designed to be streamlined as possible. Also, it tapers to the top to draw your eye where it needs to be looking, over the top of the sight, not at the sight.
We believe our systems are best when used as a complete system, front and rear. The front sight has a width of .125 and matches the factory front sight height to achieve the same point of impact as the factory sights. To match that the rear sight notch is .125 wide. This combination gives the best accuracy possible. Without lots of gap around the front sight in the sight picture you are certain to be centered better in the sight.
The speed in this system comes from the rear sight design. As your pulling the pistol and coming on target your eyes should already be looking at the target. As the pistol comes up into view and over the target there is minimal amount of sight to obscure your vision of the target. The profile of the sight also draws all vision to the top and center of the pistol. Basically, everything is lining up on target as the pistol comes up into your sight plane.
Using a wire EDM to cut the profiles and dovetail dimensions these sights are held to extremely exacting tolerances. This gives you the most consistent size from sight to sight. The rear sight is threaded for a set screw allowing for a super strong installation that won’t move under hard use.
Another benefit or our sight system is the square notch is cut deeper than most all other sights. This gives more view of the front sight and aids in the entire sight picture lining up as you bring the pistol up on target. That with the combination of a minimalist design leads to one of the fastest, most accurate, and best instinctive use sights on the market.
M&P Front Sight Black GEN 1
.125 sight width.
Same height as factory sight.
Matches factory point of aim point of impact.
Fits all M&P 9mm, .40 S&W, .357 Sig, and .45 ACP caliber pistols. Gen M1.0 and M2.0.
We reccomend this product be installed by a competent gunsmith or armorer.
Sight may require fitting. The dovetail varies a lot from year of manufacture and different generations. To accomate this variance we make our sights on the high side of the production limit. This way it will fit all slides.